Lincoln Navigator: Information and Entertainment Systems
- Information and Entertainment System - General Information - Vehicles With: SYNC 4
- Information and Entertainment System - Component Location. Description and Operation
- Information and Entertainment System - System Operation and Component Description. Description and Operation
- Information and Entertainment System. Diagnosis and Testing
- Bezel Diagnostics. General Procedures
- Speaker Audio Test. General Procedures
- AM/FM1 Antenna Amplifier. Removal and Installation
- Active Noise Control Microphone. Removal and Installation
- Audio Digital Signal Processing (DSP) Module. Removal and Installation
- Audio Front Control Module (ACM). Removal and Installation
- D-Pillar Speaker. Removal and Installation
- Front Controls Interface Module (FCIM). Removal and Installation
- Front Display Interface Module (FDIM). Removal and Installation
- Front Door Speaker. Removal and Installation
- Front Door Tweeter Speaker. Removal and Installation
- Instrument Panel Center Speaker. Removal and Installation
- Low Voltage Differential Signalling (LVDS) Cable. Removal and Installation
- Media Hub. Removal and Installation
- Overhead Speaker. Removal and Installation
- Rear Audio Control Module (RACM). Removal and Installation
- Rear Door Speaker. Removal and Installation
- Rear Door Tweeter Speaker. Removal and Installation
- Rear Passenger Entertainment Control Panel. Removal and Installation
- Satellite Radio Antenna. Removal and Installation
- Satellite Radio / Global Positioning System (GPS) Splitter / Cable. Removal and Installation
- Subwoofer Speaker. Removal and Installation
- SYNC Module [APIM]. Removal and Installation
- SYNC Module [APIM] to Universal Serial Bus (USB) Port Cable. Removal and Installation
- Telematics Control Unit (TCU) Module. Removal and Installation
- Telematics Control Unit (TCU) Module Antenna. Removal and Installation
- Video Display. Removal and Installation
- Voice Microphone. Removal and Installation
Wireless Accessory Charging Module (WACM). Removal and Installation
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Other information:
Lincoln Navigator 2018-2025 Workshop Manual: Hood Latch Release Cable. Removal and Installation
Removal Remove the hood latch release handle. Refer to: Hood Latch Release Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). Remove the air cleaner. Refer to: Air Cleaner (303-12 Intake Air Distribution and Filtering - 3.5L EcoBoost (272kW/370PS), Removal and Installation). Remove the front bumper cove..
Lincoln Navigator 2018-2025 Workshop Manual: Intake Manifold Vacuum Test. General Procedures
Bring the engine to normal operating temperature. Connect the Vacuum/Pressure Tester to the intake manifold. Run the engine at the specified idle speed. The vacuum gauge should read between 51-74 kPa (15-22 in-Hg) depending upon the engine condition and the altitude at which the test is conducted. Subtract 4.0193 kPa (1 in-Hg) from the specified reading for every..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2025)
- Identification Codes. Description and Operation
- Power Running Board (PRB). Diagnosis and Testing
- Brake Service Mode Activation and Deactivation. General Procedures
- All Terrain Control Module (ATCM). Removal and Installation
- Front Seat. Removal and Installation
Rear Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.
