Lincoln Navigator: Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Instrument Panel Center Speaker. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Information and Entertainment Systems / Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Instrument Panel Center Speaker. Removal and Installation

Special Tool(s) / General Equipment

Interior Trim Remover

Removal

NOTE: Removal steps in this procedure may contain installation details.

Release the clips and remove the instrument panel center speaker grille
Use the General Equipment: Interior Trim Remover

Remove the screws and position the instrument panel center speaker up.
Torque: 22 lb.in (2.5 Nm)

Disconnect the electrical connector and remove the instrument panel center speaker.

Installation

To install, reverse the removal procedure.

Front Door Tweeter Speaker. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal Release the clips, disconnect the electrical connector and remove the front door sail trim panel...

Low Voltage Differential Signalling (LVDS) Cable. Removal and Installation

Removal Remove the APIM . Refer to: Information and Entertainment System - Component Location (415-00 Information and Entertainment System - General Information - Vehicles With: SYNC 4, Description and Operation)...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Rear Driveshaft. Removal and Installation

Special Tool(s) / General Equipment Flat Headed Screw Driver Tire Lever Removal All vehicles With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting (100-02 Jacking and Lifting) ...

Lincoln Navigator 2018-2026 Workshop Manual: Evaporative Emission System Leak Test. General Procedures

Activation Phase 1 - Leak Verification Run the EVAP Test with the scan tool. NOTE: Some small leaks may not be detected using the EVAP Test. If the system has passed the test but a leak is still suspected, then proceed to Phase 2...

Rear Stabilizer Bar Link. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.

Remove and discard the 2 rear stabilizer bar link nuts and remove the rear stabilizer bar link.
Torque: 46 lb.ft (63 Nm)