Lincoln Navigator: Engine System - General Information / Piston Selection. General Procedures
Check
-
Refer to specifications for piston selection.
Refer to: Specifications (303-01)
.
-
NOTE:
The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston.
-
Measure the cylinder bore in 2 directions.
-
Select a piston size based on the cylinder bore.
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore...
Adjustment
NOTE:
Refer to the appropriate section and procedure for special instructions on loosening and tightening mount fasteners.
With the vehicle in NEUTRAL, position it on a hoist...
Other information:
Special Tool(s) /
General Equipment
303-1655Tool, Camshaft Holding
Removal
NOTICE:
During engine repair procedures, cleanliness is extremely
important. Any foreign material, including any material created while
cleaning gasket surfaces, that enters the oil passages, coolant passages
or the oil pan may cause engine failure...
Check
Functional Test - Seatbelt Buckle and Tongue
WARNING:
All seatbelt components must be inspected and corrected
as part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual...