Lincoln Navigator: Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Active Noise Control Microphone. Removal and Installation
Removal
-
Lower the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Disconnect the electrical connector, release the tabs and remove the active noise control microphone.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the upper RH C-pillar trim panel.
Refer to: C-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Other information:
Special Tool(s) /
General Equipment
Electric Drill
Removal
NOTE:
Driver seat shown, passenger seat similar.
NOTE:
Positioning the seat fully upward provides access to
service the seat track motor with the seat in the vehicle...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...