Lincoln Navigator: Front Drive Axle/Differential / Axle Tube Bearing. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Driveline / Front Drive Axle/Differential / Axle Tube Bearing. Removal and Installation

Special Tool(s) / General Equipment

	205-123 (T78P-1177-A) Installer, Axle Shaft Oil Seal
	308-047 (T77F-1102-A) Remover, Bearing Cup
Slide Hammer

Removal

Remove the axle shaft seal.
Refer to: Axle Shaft Seal (205-03 Front Drive Axle/Differential, Removal and Installation).

NOTE: Right side shown, left side similar.
Using special tool and a slide hammer, remove and discard the axle shaft pilot bearing.
Use Special Service Tool: 308-047 (T77F-1102-A) Remover, Bearing Cup.
Use the General Equipment: Slide Hammer

Installation

Using the special tool, install the new axle shaft bearing.
Use Special Service Tool: 205-123 (T78P-1177-A) Installer, Axle Shaft Oil Seal.

Install the axle shaft seal.
Refer to: Axle Shaft Seal (205-03 Front Drive Axle/Differential, Removal and Installation).

Axle Shaft Seal. Removal and Installation

Special Tool(s) / General Equipment 205-153 (T80T-4000-W) Handle 206-034 (T88P-20202-B) Installer, Wheel Speed Sensor RingTKIT-1988-FLMTKIT-1988-LM 307-397Remover, Transmission Fluid PumpTKIT-2002N-DEWTKIT-2000AP-FLM/LM Slide Hammer Removal Remove the halfshaft...

Differential Bearings. Removal and Installation

Special Tool(s) / General Equipment 100-002 (TOOL-4201-C) Holding Fixture with Dial Indicator Gauge 205-001 (TOOL-4000-E) Spreader, Differential Carrier 205-005 (T53T-4621-C) Installer, Drive Pinion Bearing Cone 205-010 (T57L-4221-A2) Installer, Differential Side Bearing 205-024 (T67P-4616-A) Installer, Drive Pinion Bearin..

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Tire Pressure Monitoring System (TPMS) - Component Location. Description and Operation

Item Description 1 RTM 2 BCM 3 TPMS sensor assembly (4 required) ..

Lincoln Navigator 2018-2026 Workshop Manual: Intake Air Distribution and Filtering - Overview. Description and Operation

Overview The air intake system cleans intake air with a replaceable, dry-type engine Air Cleaner (ACL) element made of treated, pleated paper. A new Air Cleaner (ACL) element must be installed periodically as scheduled. Engine performance and fuel economy are adversely affected when maximum restriction of the Air Cleaner (ACL) element is reached. The Charge air Cooler (CAC) subsyste..

Axle Tube Bearing. Removal and Installation

Special Tool(s) / General Equipment

205-123 (T78P-1177-A)
Installer, Axle Shaft Oil Seal

308-047 (T77F-1102-A)
Remover, Bearing Cup Slide Hammer