Lincoln Navigator: Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Rear Door Speaker. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Information and Entertainment Systems / Information and Entertainment System - General Information - Vehicles With: SYNC 4 / Rear Door Speaker. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

All door speakers

Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

Mid range speaker

Disconnect the electrical connector, remove the screws and the mid range speaker.
Torque: 13 lb.in (1.5 Nm)

Woofer speaker

Disconnect the electrical connector, remove the screws and the rear door speaker.
Torque: 13 lb.in (1.5 Nm)

Installation

To install, reverse the removal procedure.

Rear Audio Control Module (RACM). Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module...

Rear Door Tweeter Speaker. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear door trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Transmission Fluid Pump Idler Gear. Removal and Installation

Special Tool(s) / General Equipment 205-1018Installation Tube 307-003 (T57L-500-B) Holding Fixture, Transmission 307-091Handle, Torque ConverterTKIT-2009TC-F 307-346 (T97T-7902-A) Retainer, Torque ConverterTKIT-1998-LM (NavigatoR)TKIT-1997-F/FLM/LT 307-736Installer, Pump Drive Gear Bearing 307-737Press Tool, Oil Pump Drive ..

Lincoln Navigator 2018-2026 Workshop Manual: Piston. Disassembly and Assembly of Subassemblies

DISASSEMBLY Remove the piston rings and discard. Remove the piston pin retainers and discard. Remove the piston pin. NOTE: If the piston and connecting rod are to be reinstalled, they must be assembled in the same orientation. Mark the piston orientati..

Diagnostic Methods. Description and Operation

This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual.

Ford Diagnostic Assumptions

Ford diagnostics assume the vehicle concern described by the test title is currently present. Exceptions to this rule are noted in each test. Do not replace modules or other components as directed by a diagnostic if the concern is not present at the time of testing.