Lincoln Navigator: Body and Paint / Interior Trim and Ornamentation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH shown, RH similar.
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
If installing a new BCM , connect a battery charger to the battery to
make sure it is charged to maintain proper battery voltage.
Refer to: Battery Charging (414-01 Battery, Mounting and Cables, General Procedures)...
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
Upload the Direct Current/Direct Current (DC/DC)
configuration to the scan tool by following the scan tool on-screen
instructions...