Lincoln Navigator: Interior Trim and Ornamentation / Rear Door Trim Panel. Removal and Installation
Special Tool(s) /
General Equipment
Removal
-
Release the clips and remove the rear door handle trim cover.
Use the General Equipment: Pick Hook
-
Remove the rear door trim panel center bolts.
Short wheel base
-
Remove the rear door trim panel lower bolt.
Long wheel base
-
Remove the rear door trim panel lower bolts.
All vehicles
-
Release the rear door trim panel clips.
-
Remove the rear door trim panel.
-
Lift upward and outward on the rear door trim panel.
-
Release the tab and disconnect the interior rear door handle cable.
-
Disconnect the rear door trim panel wiring harness electrical connector.
Installation
-
To install, reverse the removal procedure.
-
Transfer parts as necessary.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH shown, RH similar.
NOTE:
Long wheelbase shown, short wheelbase similar...
Special Tool(s) /
General Equipment
Flat-Bladed Screwdriver
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
WARNING:
Do not smoke, carry lighted tobacco or have an open flame of
any type when working on or near any fuel-related component. Highly
flammable mixtures may be present and may be ignited. Failure to follow
these instructions may result in serious personal injury...
Overview
The ABS
and stability control systems are comprised of the following
subsystems which assist the driver in maintaining control of the
vehicle:
ABS
Auto hold (EPB )
EBB
Drive away release (EPB )
EBD
EPB control
ESC
Hill descent control
Hill start assist
RSC
..