Lincoln Navigator: Bumpers / Rear Bumper. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
-
Disconnect the electrical connector, separate the wiring harness guides and position the wiring harness aside.
-
With the help of an assistant.
Remove the bolts and the rear bumper.
Torque:
173 lb.ft (235 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front wheels and tires.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation)...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
Side obstacle detection control module
NOTE:
This step is only necessary if the SODL or SODR is being replaced.
Using a diagnostic scan tool, begin the PMI process for the SODL or SODR following the on-screen instructions...
Removal
NOTICE:
The turbocharger compressor vanes can be damaged by even the
smallest particles. When removing any turbocharger or engine air intake
system component, ensure that no debris enters the system. Failure to
do so may result in damage to the turbocharger...