Lincoln Navigator: Automatic Transmission / Transfer Case
- Specifications
- Transfer Case - Overview. Description and Operation
- Transfer Case. Diagnosis and Testing
- Transfer Case Draining and Filling. General Procedures
- Transfer Case Front Output Shaft Seal - Vehicles With: 1-Speed Torque On Demand Transfer Case. Removal and Installation
- Transfer Case Rear Seal. Removal and Installation
- Transfer Case. Removal
- Transfer Case - Vehicles With: 1-Speed Torque On Demand Transfer Case. Disassembly and Assembly
- Transfer Case. Installation
Transfer Case Shift Motor. Removal and Installation
Removal
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02)
.
Disconnect the wiring harness connector...
Specifications
Item
Fill Capacity
Material: Motorcraft® MERCON® LV Automatic Transmission Fluid
/ XT-10-QLVC
(WSS-M2C938-A)
(MERCON® LV, )
1...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Rear Fender Splash Shield. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. All vehicles Remove the RH side rear wheel. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation)...
Lincoln Navigator 2018-2026 Workshop Manual: Active Grille Shutter - Overview. Description and Operation
Overview The active grille shutter system is primarily used to maximize fuel economy by reducing aerodynamic drag on the vehicle. It is also used to shorten engine warm-up time, increasing engine efficiency and providing heat to the vehicle occupants in a timely manner...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Windshield Washer Pump. Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
- Liftgate Trim Panel. Removal and Installation
- Brake Service Mode Activation and Deactivation. General Procedures
- Power Running Board (PRB). Diagnosis and Testing
Rear Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.
