Lincoln Navigator: Front Disc Brake / Brake Disc Shield. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Remove the brake disc.
Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation).
-
Remove the bolts and the brake disc shield.
Torque: 133 lb.in (15 Nm)
 |
Installation
-
To install, reverse the removal procedure.
Brake Disc. Removal and Installation
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Brake Pads. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
2WD shown, 4WD similar.
Remove the wheel and tire...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Tie Rod End. Removal and Installation
Special Tool(s) / General Equipment Tie Rod End Remover Removal NOTE: Removal steps in this procedure may contain installation details. NOTICE: Disconnect the battery ground cable anytime the steering linkage is being serviced or damage to the steering gear may occur resulting in steering gear replacement...
Lincoln Navigator 2018-2026 Workshop Manual: Factory Mode Deactivation. General Procedures
Deactivation NOTE: During vehicle build, some modules, such as the IPC and BCM are set in factory mode. Factory mode reduces the drain on the battery during longer periods where the vehicle is not used. While in the factory mode, various systems may be altered or disabled and the IPC displays FACTORY MODE CONTACT DEALER in the message center...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- SYNC Module [APIM]. Removal and Installation
- Identification Codes. Description and Operation
- Liftgate Trim Panel. Removal and Installation
- Remote Function Actuator (RFA) Module. Removal and Installation
- Neutral Flat Tow Activation and Deactivation. General Procedures
Rear Camber Adjustment. General Procedures
Special Tool(s) / General Equipment
Wheel Alignment SystemActivation
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
Using alignment equipment and the manufacturer's instructions, measure the rear camber.Use the General Equipment: Wheel Alignment System
