Lincoln Navigator: Fuel Charging and Controls - 3.5L EcoBoost (272kW/370PS) / Fuel Injectors. Removal and Installation
Removal and Installation
-
The fuel injectors are removed with the fuel rails.
Refer to: Direct Injection Fuel Rail LH (303-04A Fuel Charging and
Controls - 3.5L EcoBoost (272kW/370PS), Removal and Installation).
Refer to: Direct Injection Fuel Rail RH (303-04A Fuel Charging and
Controls - 3.5L EcoBoost (272kW/370PS), Removal and Installation).
Refer to: Port Injection Fuel Rail (303-04A Fuel Charging and Controls -
3.5L EcoBoost (272kW/370PS), Removal and Installation).
Refer to: Port Injection Fuel Rail (303-04A Fuel Charging and Controls -
3.5L EcoBoost (272kW/370PS), Removal and Installation).
Special Tool(s) /
General Equipment
303-1567Sizer, Teflon SealTKIT-2010C-FLM
307-005
(T59L-100-B)
Slide Hammer
310-205Fuel Injector Brush
310-206Remover, Fuel InjectorTKIT-2009A-FLM
310-207Installer, Fuel Injector Seal AssemblyTKIT-2009A-FLM
Removal
Remove the port injection fuel rail...
Removal
NOTE:
The fuel pump driver module may be in either of two locations.
NOTE:
The top-frame-mounted fuel pump driver module is on top of the left frame rail, behind the left rear wheel...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the front wheel and tire assembly.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation)...
Removal
If a new IPMA is being installed, using a diagnostic scan tool, begin
the PMI process for the IPMA following the on-screen instructions.
Disconnect the trailer tow lighting module electrical connectors.
Remove the bolts and trailer tow lighting module...