Lincoln Navigator: Suspension / Front Suspension - LHD 4WD
Special Tool(s) /
General Equipment
Surface Gauge
Check
Ride Height Measurement — Front
NOTE:
Make sure that the vehicle is positioned on a
flat, level surface and the tires are inflated to the correct pressure...
Overview
The 4WD front suspension consists of the following components:
Lower ball joints
Lower control arms
Ride height sensors (Vehicles with Continuously Controlled Damping (CCD) Suspension)
Stabilizer bar, bushings and links
Shock absorber and coil spring assemblies
Upper control arms
Wheel bearing and wheel hubs
Wheel kn..
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH seat shown, others similiar.
Remove the second row seat manual release handle bezel.
Slide the release handle bezel rearward.
Use the General Equipment: Interior Trim Remover
Pull the release handle bezel upward and out.
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the second row center seat backrest cover.
Refer to: Second Row Center Seat Backrest Cover (501-10B Second Row Seats, Removal and Installation).
Remove the second row center seatbelt retractor.
Remove and discard the nut.
Torque:
30 lb.ft (40 Nm)
..