Lincoln Navigator: Climate Control System - General Information / Ambient Air Temperature Sensor. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
-
Disconnect the electrical connector. Detach and remove the ambient air temperature sensor.
Installation
-
To install, reverse the removal procedure.
-
NOTE:
This step is only necessary if replacing the ambient air temperature sensor.
If replacing the ambient air temperature sensor a reset must be performed.
Refer to: Reset the Outside Air Temperature Sensor Learned Values
(412-00 Climate Control System - General Information, General
Procedures).
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the instrument panel.
Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the push pins and the RH insulation panel...
Other information:
Special Tool(s) /
General Equipment
205-086
(T74P-4635-C)
Installer/Remover, C-Frame and Screw
Vise
Materials
Name
Specification
Motorcraft® Premium Long-Life GreaseXG-1-E1
ESA-M1C75-B
DISASSEMBLY
NOTICE:
Do not, under any circumstance, clamp the driveshaft
assembly in the jaws of a vise or similar holding fixture...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Disconnect the rear air distribution door actuator electrical connector...