Lincoln Navigator: Roof Opening Panel / Roof Opening Panel - Component Location. Description and Operation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Roof Opening Panel / Roof Opening Panel - Component Location. Description and Operation

Roof Opening Panel Front Drain Hose Routing

Roof Opening Panel Rear Drain Hose Routing

Specifications

Specifications Item Specification Fixed glass panel to roof flushness, side (at front of glass) 0...

Roof Opening Panel - Overview. Description and Operation

Overview The roof opening panel consists of the following: Air deflector Front sliding glass panel (sunroof) Front sliding glass panel motor (sunroof motor) Shield (sunshade) assembly Shield (sunshade) motor Blinds (concertina blinds) Roof panel fixed glass (panoramic) Roof opening panel frame assembly Roof opening panel dr..

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Roof Opening Panel Fixed Glass. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the roof opening panel frame. Refer to: Roof Opening Panel Frame (501-17 Roof Opening Panel, Removal and Installation). NOTE: Position the roof opening panel frame upside down on a suitable workbench. Remove the the roof opening panel fixed glass bolts and wit..

Lincoln Navigator 2018-2026 Workshop Manual: D-Pillar Moulding. Removal and Installation

Special Tool(s) / General Equipment Blind Rivet Gun 6 mm Drill Bit Removal NOTE: LWB (long wheel base) shown, SWB (short wheel base) similar. NOTE: RH side shown, LH side similar. Open the liftgate. Using a non-marring trim tool, detach the push pin retainers and remove the bodyside mou..

Rear Camber Adjustment. General Procedures

Special Tool(s) / General Equipment

Wheel Alignment System

Activation

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Using alignment equipment and the manufacturer's instructions, measure the rear camber.
Use the General Equipment: Wheel Alignment System