Lincoln Navigator: Automatic Transmission - 10-Speed Automatic Transmission – 10R80 / Adaptive Learning Drive Cycle. General Procedures
Programming
NOTE: Perform the adaptive learning drive cycle on a level road surface.
-
Using the scan tool, clear the DTCs (Diagnostic Trouble Codes) and Transmission Adaptive Tables.
-
Drive the vehicle until the engine and transmission reach normal operating temperature.
-
Accelerate from a stop with light throttle (15%)
ensuring that upshifts 1st through 8th occur at engine speeds between
1300-1600 rpm.
-
Continue to accelerate (may apply slightly more throttle
after 7-8 upshift at 32-38 mph (51-61 km/h) until you achieve 55 mph
(88 km/h) and the 8-9 and 9-10 shifts complete.
-
Brake very gently to a complete stop and hold foot on brake for five (5) seconds.
-
Shift the transmission to Neutral. Wait 1 second.
-
Shift the transmission to Reverse. Wait 2 seconds.
-
Shift the transmission to Neutral. Wait 1 second.
-
Shift the transmission to Drive. Wait 2 seconds.
-
Repeat Steps 3 through 9 six additional times.
Torque Converter Clutch (TCC). Diagnosis and Testing
Torque Converter Clutch (TCC)
For torque converter operation, REFER to: Torque Converter (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Description and Operation)...
Transmission Fluid Drain and Refill. General Procedures
Special Tool(s) /
General Equipment
Fluid Suction Gun
Universal Fluid Dispenser
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
Draining
NOTE:
It is not necessary to remove the transmission fluid filter to drain the transmission fluid...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Module Configuration - System Operation and Component Description. Description and Operation
System Operation Overview Over the Air (OTA) Programming Over-the-Air updates allow for vehicle system software to be updated wirelessly over Wi-Fi (both private and or public Wi-Fi connection) and or the vehicle cellular network. Over-the-Air updates occur on a rolling basis...
Lincoln Navigator 2018-2026 Workshop Manual: Air Conditioning (A/C) Pressure Transducer. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect the electrical connector and remove the A/C pressure transducer. Torque: 71 lb.in (8 Nm) Installation To install, reverse the removal procedure...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Brake Service Mode Activation and Deactivation. General Procedures
- Front Bumper Cover. Removal and Installation
- Body and Paint
- Body Control Module (BCM). Removal and Installation
- Transmission Fluid Level Check. General Procedures
Rear Camber Adjustment. General Procedures
Special Tool(s) / General Equipment
Wheel Alignment SystemActivation
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
Using alignment equipment and the manufacturer's instructions, measure the rear camber.Use the General Equipment: Wheel Alignment System
