Lincoln Navigator: Climate Control System - General Information / Reset the Outside Air Temperature Sensor Learned Values. General Procedures

Lincoln Navigator 2018-2025 Workshop Manual / Climate Control System / Climate Control System - General Information / Reset the Outside Air Temperature Sensor Learned Values. General Procedures

Configuration

NOTE: The ambient air temperature sensor is a critical component for correct Air Conditioning (A/C) and Heating, Ventilation, and Air Conditioning (HVAC) system operation. Make sure after the reset is carried out the temperature is displaying correctly in the vehicle.

NOTE: The outside air temperature sensor is also referred to as the ambient air temperature sensor in this manual.
Using the diagnostic FDRS scan tool, follow the on screen prompts to run and reset the outside air temperature sensor learned values.

Refrigerant System Tests - 3.5L EcoBoost (272kW/370PS). General Procedures

Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: To perform an accurate test make sure the vehicle ambient temperature is 21 °C (70 °F) or above...

Air Conditioning (A/C) Clutch and Air Conditioning (A/C) Clutch Field Coil. Removal and Installation

Special Tool(s) / General Equipment Snap Ring Pliers Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Lincoln Navigator 2018-2025 Workshop Manual: Parking, Rear and License Plate Lamps. Diagnosis and Testing

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action BCM B10F3:11 Left front position light: Circuit Short To Ground GO to Pinpoint Test D BCM B10F3:..

Lincoln Navigator 2018-2025 Workshop Manual: Driveshaft Center Bearing Bracket. Removal and Installation

Special Tool(s) / General Equipment Grinder MIG/MAG Welding Equipment Locking Pliers Removal NOTE: The following applies to left hand (LH) drive/rear wheel drive (RWD) vehicles only. Restore the vehicle to manufacturer's dimensions. Refer to: Body and Frame (501-26 Body Repairs - Vehicle Specific Information and Tolerance Checks, Descripti..

Rear Camber Adjustment. General Procedures

Special Tool(s) / General Equipment

Wheel Alignment System

Activation

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Using alignment equipment and the manufacturer's instructions, measure the rear camber.
Use the General Equipment: Wheel Alignment System