Lincoln Navigator: Parking Brake and Actuation / Parking Brake - Overview. Description and Operation
Overview
The parking brake system uses 2 switch activated, ECU controlled motors to apply and release the rear brake calipers. The ABS module controls and monitors the parking brake system and sets Diagnostic Trouble Codes (DTCs) when a fault is present in the system. The IPC illuminates the parking brake warning indicator and displays a message in the message center when a fault is present, when the parking brakes are applied and when they are released.
Parking Brake - Overview. Description and Operation
Overview
The parking brake system uses 2 switch activated, ECU controlled motors to apply and release the rear brake calipers. The ABS
module controls and monitors the parking brake system and sets
Diagnostic Trouble Codes (DTCs) when a fault is present in the system...
Parking Brake - Overview. Description and Operation
Overview
The parking brake system uses 2 switch activated, ECU controlled motors to apply and release the rear brake calipers. The ABS
module controls and monitors the parking brake system and sets
Diagnostic Trouble Codes (DTCs) when a fault is present in the system...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Locked Seatbelt Retractor Releasing. General Procedures
Repair NOTE: If the seatbelt webbing does not extract from the seatbelt retractor from the stowed position, this may be due to a normal condition which happens when the seatbelt retracts at a high rate of speed. Follow these steps to release the seatbelt...
Lincoln Navigator 2018-2026 Workshop Manual: Seatbelt Twisted at the Seatbelt Guide. General Procedures
Adjustment NOTE: Typical D-ring shown, others similar. If required, remove the necessary trim panel(s). Fold the seatbelt as indicated. Feed the folded portion of the seatbelt into the D-ring...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Head Up Display (HUD) Module Calibration. General Procedures
- Body Control Module (BCM). Removal and Installation
- SYNC Module [APIM]. Removal and Installation
- Rear Bumper. Removal and Installation
Axle Tube Bearing. Removal and Installation
Special Tool(s) / General Equipment
205-123
(T78P-1177-A)
Installer, Axle Shaft Oil Seal
308-047
(T77F-1102-A)
Remover, Bearing Cup Slide Hammer
