Lincoln Navigator: Parking Brake and Actuation / Parking Brake - Overview. Description and Operation
Overview
The parking brake system uses 2 switch activated, ECU controlled motors to apply and release the rear brake calipers. The ABS module controls and monitors the parking brake system and sets Diagnostic Trouble Codes (DTCs) when a fault is present in the system. The IPC illuminates the parking brake warning indicator and displays a message in the message center when a fault is present, when the parking brakes are applied and when they are released.
Parking Brake - Overview. Description and Operation
Overview
The parking brake system uses 2 switch activated, ECU controlled motors to apply and release the rear brake calipers. The ABS
module controls and monitors the parking brake system and sets
Diagnostic Trouble Codes (DTCs) when a fault is present in the system...
Parking Brake Switch. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the HVAC control module.
Refer to: Heating, Ventilation and Air Conditioning (HVAC) Control
Module (412-00 Climate Control System - General Information, Removal and
Installation)...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Remote Keyless Entry (RKE) Exterior Sounder. Removal and Installation
Removal On the left side. Remove the fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation). Remove the RKE exterior sounder. Disconnect the RKE exterior sounder electrical connector...
Lincoln Navigator 2018-2026 Workshop Manual: Climate Control System Health and Safety Precautions. Description and Operation
WARNING: Air conditioning liquid refrigerant R-134a and R-1234yf are capable of harming eyes or freezing skin. Always wear safety goggles and avoid contact with liquid refrigerant. Failure to follow these instructions may result in serious personal injury...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Body Control Module (BCM). Removal and Installation
- Neutral Flat Tow Activation and Deactivation. General Procedures
- Remote Function Actuator (RFA) Module. Removal and Installation
- SYNC Module [APIM]. Removal and Installation
- Transmission Fluid Drain and Refill. General Procedures
Front Driveshaft. Removal and Installation
Special Tool(s) / General Equipment
Crimping ToolMaterials
Name Specification Motorcraft® Premium Long-Life GreaseXG-1-E1 ESA-M1C75-B
Removal
With the vehicle in NEUTRAL, position the vehicle on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
Remove the bolts and the transmission shield.
