Lincoln Navigator: Collision Warning and Collision Avoidance System / Head Up Display (HUD) Module. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Electronic Feature Group / Collision Warning and Collision Avoidance System / Head Up Display (HUD) Module. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the instrument panel.
Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation).

Disconnect the electrical connector, remove the bolts and the HUD module.
Torque: 80 lb.in (9 Nm)

Installation

To install, reverse the removal procedure.

Carry out the adjustments for the HUD module display.
Refer to: Head Up Display (HUD) Module Calibration (419-03B Collision Warning and Collision Avoidance System, General Procedures).

Head Up Display (HUD) Module Calibration. General Procedures

Special Tool(s) / General Equipment 501-418Calibration Target - NO STEP File Available 501-419Hud Eye Box Adjustment NOTE: If it is necessary to cancel any calibration adjustment use the return button to cancel the current adjustment...

Side and Rear Vision

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Rear Fog Lamp. Removal and Installation

Removal NOTE: RH (right-hand) rear fog lamp shown, LH (left-hand) similar. Remove the nuts and the rear fog lamp. Disconnect the electrical connector. Installation To install, reverse the removal procedure. ..

Lincoln Navigator 2018-2026 Workshop Manual: Noise, Vibration and Harshness (NVH). Description and Operation

Acceptable Noise, Vibration and Harshness (NVH) Noise is any undesirable sound, usually unpleasant in nature. Vibration is any motion, shaking or trembling, that can be felt or seen when an object moves back and forth or up and down. Harshness is a ride quality issue where the vehicle's response to the road transmits sharply to the customer. Harshness normally describes a firmer th..

Axle Tube Bearing. Removal and Installation

Special Tool(s) / General Equipment

205-123 (T78P-1177-A)
Installer, Axle Shaft Oil Seal

308-047 (T77F-1102-A)
Remover, Bearing Cup Slide Hammer