Lincoln Navigator: Evaporative Emissions - 3.5L EcoBoost (272kW/370PS) / Evaporative Emission Canister. Removal and Installation

Removal

  WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures may be present and may be ignited. Failure to follow these instructions may result in serious personal injury.

  WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures may be present and may be ignited. Failure to follow these instructions may result in serious personal injury.

  WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures may be present and may be ignited. Failure to follow these instructions may result in serious personal injury.

NOTE: Removal steps in this procedure may contain installation details.

1. With the vehicle in NEUTRAL, position it on a hoist.
   Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
   

1. Disconnect the EVAP canister electrical connector.
   

1. Disconnect the quick connect couplings.
   Refer to: Quick Release Coupling (310-00) .
   

1. Detach the fuel line routing clip from the EVAP canister and position the line aside.
   

1. Remove the bolts and the EVAP canister.
   Torque: 124 lb.in (14 Nm)

Installation

1. To install, reverse the removal procedure.