Lincoln Navigator: Evaporative Emissions - 3.5L EcoBoost (272kW/370PS) / Evaporative Emission Blocking Valve. Removal and Installation
Removal
-
Remove the fuel tank.
Refer to: Fuel Tank (310-01 Fuel Tank and Lines - 3.5L EcoBoost (272kW/370PS), Removal and Installation).
-
-
Disconnect the EVAP quick connect coupling.
Refer to: Quick Release Coupling (310-00) .
-
Release the hose routing clips and remove the EVAP blocking valve.
-
Disconnect the EVAP quick connect coupling.
 |
Installation
-
To install, reverse the removal procedure.
Evaporative Emission System Leak Test. General Procedures
Activation
Phase 1 - Leak Verification
Run the EVAP Test with the scan tool.
NOTE:
Some small leaks may not be detected using the EVAP Test...
Evaporative Emission Canister. Removal and Installation
Removal
WARNING:
Do not smoke, carry lighted tobacco or have an open flame of
any type when working on or near any fuel-related component...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Passive Anti-Theft System (PATS) - Overview. Description and Operation
Overview PATS uses the following main components: BCM Keyless entry rear antenna/PATS antenna Passive key PATS front antenna PCM RTM Start/Stop Switch When the START/STOP button is pressed, the key data is read by a PATS antenna...
Lincoln Navigator 2018-2026 Workshop Manual: Halfshaft. Removal and Installation
Special Tool(s) / General Equipment 204-592Separator, Lower Arm Ball JointTKIT-2006C-FFMFLMTKIT-2006C-LMTKIT-2006C-ROW Tie Rod End Remover Tire Lever Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Head Up Display (HUD) Module Calibration. General Procedures
- Neutral Flat Tow Activation and Deactivation. General Procedures
- Telematics Control Unit (TCU) Module. Removal and Installation
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Body Control Module (BCM). Removal and Installation
Rear Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.
