Lincoln Navigator: Seatbelt Systems / Third Row Single Seat Seatbelt Buckle. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Seatbelt Systems / Third Row Single Seat Seatbelt Buckle. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the third row single seat.
Refer to: Third Row Seat (501-10C Third Row Seats, Removal and Installation).

Remove the third row single seat seatbelt buckle.
1. If equipped.
  Detach the wiring harness retainer.
1. If equipped.
  Detach and disconnect the electrical connector.
1. Remove the bolt.
  Torque: 30 lb.ft (40 Nm)

Installation

NOTE: During installation, make sure the seatbelt webbing is not twisted and the seatbelts and buckles are accessible to the occupants.

To install, reverse the removal procedure.

Check the seatbelt system for correct operation.
Refer to: Seatbelt System Functional Tests (501-20A Seatbelt Systems, General Procedures).

Third Row Seatbelt Retractor Bracket - Long Wheelbase. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH shown, RH similar. Lower the headliner...

Supplemental Restraint System

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Transfer Case Shift Motor. Removal and Installation

Removal With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting (100-02) . Disconnect the wiring harness connector. Detach wiring harness retainers. Remove the coil wire pin from the electrical connector. Remove the inner retainer from the w..

Lincoln Navigator 2018-2026 Workshop Manual: Second Row Seat Cushion Adjuster - Vehicles With: Multi-Contour Seats. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Right hand (RH) shown, left hand (LH) similar. Remove the second row single seat cover. Refer to: Second Row Single Seat Cushion Cover - Vehicles With: Multi-Contour Seats (501-10B Second Row Seats, Removal and Installation). Disconnect the second row sea..

Front Stabilizer Bar Link. Removal and Installation

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

NOTICE: Do not use power tools to remove or install the stabilizer bar