Lincoln Navigator: Wheels and Tires / Specifications
Material
| Item | Specification | Fill Capacity |
|---|---|---|
| High Temperature Nickel Anti-Seize Lubricant / XL-2 | - | - |
| Motorcraft® Wheel and Tire Cleaner - ZC-37-A | - | - |
General Specifications
| Item | Specification |
|---|---|
| Tire Inflation | |
| Tires | See Safety Certification Label on driver door jamb |
| Wheel Weights | |
| Wheel weight type | Use a wheel weight manufacturer's rim gauge to determine the correct wheel weight application |
Torque Specifications
| Item | Nm | lb-ft | lb-in |
|---|---|---|---|
| Valve stem-to-TPMS sensor screw | 1.5 | - | 13 |
| Wheel nutsa | - | - | - |
aRefer to the procedure in this section.
Safety Precautions - Overview. Description and Operation
Overview
Before beginning any service procedure in this manual, refer to health
and safety warnings in section 100-00 General Information. Failure to
follow this instruction may result in serious personal injury...
Other information:
Lincoln Navigator 2018-2025 Workshop Manual: Outer Constant Velocity (CV) Joint Boot. Removal and Installation
Special Tool(s) / General Equipment Flat Headed Screw Driver Boot Clamp Pliers Removal Remove the inner CV joint boot. Refer to: Inner Constant Velocity (CV) Joint Boot (205-05 Rear Drive Halfshafts, Removal and Installation)...
Lincoln Navigator 2018-2025 Workshop Manual: Refrigerant System Tests - 3.5L EcoBoost (272kW/370PS). General Procedures
Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: To perform an accurate test make sure the vehicle ambient temperature is 21 °C (70 °F) or above. Perform the following steps to achieve normal operating pressures...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2025)
- Identification Codes. Description and Operation
- Body Control Module (BCM). Removal and Installation
- Rear Bumper. Removal and Installation
- Front Seat. Removal and Installation
- Power Running Board (PRB). Diagnosis and Testing
Rear Camber Adjustment. General Procedures
Special Tool(s) / General Equipment
Wheel Alignment SystemActivation
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
Using alignment equipment and the manufacturer's instructions, measure the rear camber.Use the General Equipment: Wheel Alignment System
