Lincoln Navigator: Anti-Lock Brake System (ABS) and Stability Control / Rear Wheel Speed Sensor. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Brake System / Anti-Lock Brake System (ABS) and Stability Control / Rear Wheel Speed Sensor. Removal and Installation

Materials

Name	Specification
Motorcraft® Metal Brake Parts Cleaner PM-4-A, PM-4-B, APM-4-C	-

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the brake disc shield.
Refer to: Brake Disc Shield (206-04 Rear Disc Brake, Removal and Installation).

Disconnect the wheel speed sensor electrical connector and detach the retainers.

Using compressed air, clean the area surrounding the rear wheel speed sensor.

Detach the wiring retainer, remove the bolt and the rear wheel speed sensor.
Torque: 150 lb.in (17 Nm)

Installation

To install, reverse the removal procedure.

Before installing a new sensor, inspect the sensor housing to make sure the sensor cavity is clean and free of foreign material.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B, APM-4-C

Rear Wheel Speed Sensor. Removal and Installation

Materials Name Specification Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C - Removal NOTE: Removal steps in this procedure may contain installation details...

Auxiliary Brake System

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Cooling Module. Removal and Installation

Special Tool(s) / General Equipment Hose Clamp Remover/Installer Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation). Drain the cooling system. Refer to: Engine Cooli..

Lincoln Navigator 2018-2026 Workshop Manual: Front Seat Track Motor. Removal and Installation

Special Tool(s) / General Equipment Electric Drill Removal NOTE: Driver seat shown, passenger seat similar. NOTE: Positioning the seat fully upward provides access to service the seat track motor with the seat in the vehicle. Raise the front seat to the full upward position. Depower the SRS . Ref..

Front Driveshaft. Removal and Installation

Special Tool(s) / General Equipment

Crimping Tool

Materials

Name Specification Motorcraft® Premium Long-Life Grease
XG-1-E1 ESA-M1C75-B

Removal

With the vehicle in NEUTRAL, position the vehicle on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
Remove the bolts and the transmission shield.