Lincoln Navigator: Exterior Lighting / Rear Fog Lamp. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Lighting / Exterior Lighting / Rear Fog Lamp. Removal and Installation

Removal

NOTE: RH (right-hand) rear fog lamp shown, LH (left-hand) similar.

Remove the nuts and the rear fog lamp.
- Disconnect the electrical connector.

Installation

To install, reverse the removal procedure.

Lighting Driver Control Module. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH (left-hand) headlamp assembly shown, RH (right-hand) headlamp assembly similar...

Rear Lamp Assembly. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH (left-hand) rear lamp assembly shown, RH (right-hand) rear lamp assembly simlar...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Condenser. Removal and Installation

Removal NOTICE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination. Remove protective materials prior to installation. NOTE: Removal steps in this procedure may contain installation details...

Lincoln Navigator 2018-2026 Workshop Manual: Rear Lamp Assembly. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH (left-hand) rear lamp assembly shown, RH (right-hand) rear lamp assembly simlar. Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation)...

Rear Camber Adjustment. General Procedures

Special Tool(s) / General Equipment

Wheel Alignment System

Activation

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Using alignment equipment and the manufacturer's instructions, measure the rear camber.
Use the General Equipment: Wheel Alignment System