Lincoln Navigator: Exhaust System - 3.5L EcoBoost (272kW/370PS) / Muffler. Removal and Installation
Removal
-
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
-
Remove the muffler and tailpipe.
Refer to: Muffler and Tailpipe (309-00 Exhaust System - 3.5L EcoBoost (272kW/370PS), Removal and Installation).
-
Loosen the clamps, and slide the clamps back on the muffler.
-
Detach the isolators, remove the bolts and the muffler.
Installation
-
Clean all exhaust connections before reassembly.
-
Install the muffler, the bolts and attach the isolators.
Torque:
18 lb.ft (25 Nm)
-
Tighten the clamps in the sequence shown.
Torque:
35 lb.ft (48 Nm)
-
Install the muffler and tailpipe.
Refer to: Muffler and Tailpipe (309-00 Exhaust System - 3.5L EcoBoost (272kW/370PS), Removal and Installation).
-
Check the exhaust system for leaks.
Removal
NOTICE:
Do not use oil or grease-based lubricants on the isolators.
These lubricants may cause deterioration of the isolator. This can lead
to separation of the isolator from the exhaust hanger bracket during
vehicle operation...
Other information:
NOTE:
If an overnight drive is done, the fan air or road air blast can cause erroneous readings.
NOTE:
When diagnosing engine oil leaks, the source and location of the leak must be positively identified prior to repair.
Prior to carrying out this procedure, clean the cylinder
block, cylinder heads, valve covers, oil pan and flywheel/flexplate with
a suitable solvent t..
System Operation
System Diagram - Exterior, Memory
E342575
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
1
Motors
2
Motors
3
LH Exterior Mirror
4
RH Exterior Mirror
..