Lincoln Navigator: Horn / Horn - Component Location. Description and Operation
Horn
Overview
The horn output is controlled by the BCM . When the horn switch is
activated, the SCCM sends a signal to the BCM . The BCM then energizes
the horn relay located in the BJB and sounds the horn(s)...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
Disconnect DCMR electrical connector by disengaging the side locking tab and pulling on the harness...