• Navigator Manuals
  • Service
  • New
  • Top
  • Sitemap
Lincoln Navigator Manuals

Lincoln Navigator: Fuel Charging and Controls - 3.5L EcoBoost (272kW/370PS) / High-Pressure Fuel Pump Drive Unit. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Engine / Fuel Charging and Controls - 3.5L EcoBoost (272kW/370PS) / High-Pressure Fuel Pump Drive Unit. Removal and Installation

Removal and Installation

  1. The high-pressure fuel pump drive unit is part of the right cylinder head.
    Refer to: Cylinder Head RH (303-01 Engine - 3.5L EcoBoost (272kW/370PS), Removal and Installation).

    High-Pressure Fuel Pump. Removal and Installation

    Removal NOTICE: Do not loosen any fittings or plugs on the high-pressure fuel pump. With the vehicle in NEUTRAL, position it on a hoist...

    Port Injection Fuel Rail. Removal and Installation

    Removal Release the fuel system pressure. Refer to: Fuel System Pressure Release (310-00 Fuel System - General Information - 3.5L EcoBoost (272kW/370PS), General Procedures)...

    Other information:

    Lincoln Navigator 2018-2026 Workshop Manual: Seat Position Sensor. Removal and Installation


    Removal NOTE: LH seat shown, RH seat similar. NOTE: Removal steps in this procedure may contain installation details. Raise the seat to the full up position. Disconnect the electrical connector...

    Lincoln Navigator 2018-2026 Workshop Manual: Perimeter Anti-Theft Alarm - System Operation and Component Description. Description and Operation


    System Operation System Diagram Item Description 1 BCM 2 DDM 3 DRDM 4 GWM 5 DLC 6 IPC 7 PDM 8 PRDM 9 Front Passenger Door Lock Control Switch 10 RKE Antenna 11 Passive Key 12 RKE And Passive E..

    Categories

    • Manuals Home
    • 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
    • Rear Bumper. Removal and Installation
    • Front Bumper Cover. Removal and Installation
    • Transmission Fluid Drain and Refill. General Procedures
    • Remote Function Actuator (RFA) Module. Removal and Installation
    • Brake Service Mode Activation and Deactivation. General Procedures

    Axle Tube Bearing. Removal and Installation

    Special Tool(s) / General Equipment

    205-123 (T78P-1177-A)
    Installer, Axle Shaft Oil Seal 308-047 (T77F-1102-A)
    Remover, Bearing Cup Slide Hammer

    read more

    Copyright © 2026 www.linavigator4.com