Lincoln Navigator: Exterior Trim and Ornamentation / Front Door Moulding. Removal and Installation
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
-
NOTICE:
To avoid damage to moulding, only use moderate force.
NOTE:
Make sure that a new component is installed.
Using a non-marring trim removal tool, disengage the retainer clips, release adhesive tape and remove moulding.
Installation
-
Clean the door panel using isopropyl alcohol or equivalent cleaner, allow to flash.
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Blind Rivet Gun
6 mm Drill Bit
Removal
NOTE:
LWB (long wheel base) shown, SWB (short wheel base) similar...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
All vehicles
Lower the door window glass completely...
Other information:
Check
NOTICE:
The vehicle should not be driven if the transmission fluid level is low. Internal failure could result.
NOTE:
If the vehicle has been operated for an extended period at
high highway speeds, in city traffic, during hot weather or while
pulling a trailer, the transmission fluid must cool down to obtain an
accurate reading...
Stay in Neutral Mode
NOTE:
Always put your vehicle in Stay in Neutral mode when
entering an automatic car wash. Failure to do this could result in
vehicle damage not covered by warranty.
Stay
in Neutral mode allows your vehicle to stay in Neutral when you exit
your vehicle...