Lincoln Navigator: Front Disc Brake / Brake Caliper Anchor Plate. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the brake pads.
Refer to: Brake Pads (206-03 Front Disc Brake, Removal and Installation).
-
Remove the bolts and the anchor plate. Discard the bolts
Torque:
184 lb.ft (250 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
NOTICE:
Make sure that all openings are sealed.
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water...
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
204-594Forcing screw
307-744Remover, Output Shaft Bearing
Remove and discard the park pawl actuator rod sleeve roll
pin (7G100), move the park pawl out of the park pawl actuator rod sleeve
and remove the park pawl actuator rod sleeve...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH shown, RH similar.
NOTE:
Long wheelbase shown, short wheelbase similar.
NOTE:
Removal steps in this procedure may contain installation details...