Lincoln Navigator: Front Disc Brake / Brake Caliper. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Brake System / Front Disc Brake / Brake Caliper. Removal and Installation

Removal

NOTICE: Make sure that all openings are sealed.

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

Remove the bolt and disconnect the brake hose. Discard the washers.
Torque: 26 lb.ft (35 Nm)

Remove the bolts and the brake caliper.
Torque: 27 lb.ft (37 Nm)

Installation

To install, reverse the removal procedure.

Bleed the brake system.
Refer to: Brake System Pressure Bleeding (206-00 Brake System - General Information, General Procedures).

Front Disc Brake

Brake Caliper Anchor Plate. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the brake pads. Refer to: Brake Pads (206-03 Front Disc Brake, Removal and Installation)...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Cowl Panel. Removal and Installation

Special Tool(s) / General Equipment 6.5 mm Drill Bit Polydrive Bit Socket Rivet Gun Self-Piercing Rivet (SPR) Remover/Installer Belt Sander Hot Air Gun Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Removal ..

Lincoln Navigator 2018-2026 Workshop Manual: Driver Front Seat Module (DSM). Removal and Installation

Removal NOTE: DSM (driver front seat module) shown, SCMB (front passenger seat control module) is similar. NOTE: Removal steps in this procedure may contain installation details. All vehicles NOTE: This step is only necessary when installing a new component. NOTE: The PMI (programmable module installation) process must begin with the current DSM (driver fr..

Front Stabilizer Bar Link. Removal and Installation

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

NOTICE: Do not use power tools to remove or install the stabilizer bar