Lincoln Navigator: Hydraulic Brake Actuation / Adjustable Pedal Indexing. General Procedures
NOTICE:
The adjustable pedal system must be indexed whenever the brake
pedal assembly or accelerator pedal assembly is installed or damage to
the components may result.
NOTE:
Typical adjustable pedal switch location shown, others similar.
-
Disconnect the adjustable pedal motor drive cable from the adjustable brake pedal drive.
-
Operate the accelerator pedal to the full rearward position.
-
Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
-
Operate the adjustable pedals until the pin is aligned with the witness mark on the brake pedal bracket.
-
Disconnect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
-
Operate the adjustable accelerator pedal forward until there
is a 4mm (0.157 in) gap between the screw head and the moving structure
of the accellerator pedal.
-
Connect the adjustable pedal motor drive cable to the adjustable brake pedal drive.
-
Check that the brake and accelerator pedals can be fully adjusted forward and rearward.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Adjustable brake pedal and bracket shown, fixed brake pedal and bracket similar...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
PCM
P00FE:00
EVAP System Tank Vapor Line Restricted/Blocked: No Sub Type Information
GO to Pinpoint Test H..
Special Tool(s) /
General Equipment
Forming Gas Pressure Gauge and Leak Detector
Materials
Name
Specification
Forming Gas
-
Leak detection
All vehicles
NOTE:
Use a Rotunda-approved Forming Gas A/C System
Dealership Leak Detection Service Kit that meets SAE J2790.
Recover the refrigerant. Refer to the appropriate Recovery p..