Lincoln Navigator: Automatic Transmission External Controls / Upshift Paddle Switch. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Remove the screw, disconnect the electrical connector and remove the upshift paddle switch.
 |
Installation
-
To install, reverse the removal procedure.
Gear Shift Module (GSM). Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Detach and position aside the ambient light bar and disconnect the wiring harness retainer...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Engine Cooling - Component Location. Description and Operation
NOTE: Coolant temperature will vary with ambient temperature and load. Temperatures shown are for ambient temperature of 38° C (100° F). Red arrows indicate a temperature over 90° C (194° F), Orange arrows indicate a temperature of approximately 90° C (194° F), Blue arrows indicate a temperature below 90° C (194° F). Item Description 1 Ra..
Lincoln Navigator 2018-2026 Workshop Manual: Rear Floor Panel. Removal and Installation
Special Tool(s) / General Equipment 6.5 mm Drill Bit Self-Piercing Rivet (SPR) Remover/Installer Belt Sander Blind Rivet Gun Knife Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Seam SealerTA-2-B, 3M™ 08308, LORD Fuso..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- All Terrain Control Module (ATCM). Removal and Installation
- Front Seat. Removal and Installation
- Power Running Board (PRB). Diagnosis and Testing
- Brake Service Mode Activation and Deactivation. General Procedures
- SYNC Module [APIM]. Removal and Installation
Diagnostic Methods. Description and Operation
This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual.
Ford Diagnostic Assumptions
Ford diagnostics assume the vehicle concern described by the test title is currently present. Exceptions to this rule are noted in each test. Do not replace modules or other components as directed by a diagnostic if the concern is not present at the time of testing.
