Lincoln Navigator: Automatic Transmission External Controls / Gear Shift Module (GSM). Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Detach and position aside the ambient light bar and disconnect the wiring harness retainer.
 |
-
Remove the screws, disconnect the electrical connector and remove the GSM .
 |
Installation
-
To install, reverse the removal procedure.
-
-
Seat both sides of the ambient light bar around the GSM .
-
Seat the passenger side of the ambient light bar.
-
Seat the center right of the ambient light bar.
-
Seat the center left of the ambient light bar.
-
Verify the P and D buttons move up and down freely.
-
Seat both sides of the ambient light bar around the GSM .
 |
Downshift Paddle Switch. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the screw, disconnect the electrical connector and remove the downshift paddle switch...
Upshift Paddle Switch. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the screw, disconnect the electrical connector and remove the upshift paddle switch...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Pump Assembly. Description and Operation
Overview Item Description 1 Transmission fluid pump drive gear 2 Transmission fluid pump idler gear 3 Transmission fluid pump assembly 4 Transmission fluid filter The transmission fluid in the sump area at the bottom of the transm..
Lincoln Navigator 2018-2026 Workshop Manual: B-Pillar and Reinforcement. Removal and Installation
Special Tool(s) / General Equipment 6.5 mm Drill Bit Polydrive Bit Socket Self-Piercing Rivet (SPR) Remover/Installer Belt Sander Blind Rivet Gun Hot Air Gun Locking Pliers Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Remo..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Front Bumper Cover. Removal and Installation
- SYNC Module [APIM]. Removal and Installation
- Rear Bumper. Removal and Installation
- Brake Service Mode Activation and Deactivation. General Procedures
- Windshield Washer Pump. Removal and Installation
Rear Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.
