Lincoln Navigator: Roof Opening Panel / Roof Opening Panel Glass. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Fully open the roof opening panel shield.
   

1. Vent the roof opening panel glass.
   

1. NOTE: During installation, make sure the blind is fully seated. An audible noise will be heard when the blind seats to the lower bracket.

   RH side shown, LH side similar. Remove the roof opening panel blind by pulling inward on the top and bottom of the roof opening panel blind and discard.
   

1. Close the roof opening panel glass.
   

1. NOTE: RH side shown, LH side similar.

   With the help of an assistant.
   Remove the bolts and the roof opening panel glass.
   Torque: 35 lb.in (4 Nm)

Installation

1. To install, reverse the removal procedure.
   

1. Align the roof opening panel glass.
   Refer to: Roof Opening Panel Alignment (501-17 Roof Opening Panel, General Procedures).
   

1. Carry out the roof opening panel initialization.
   Refer to: Power Roof Opening Panel Initialization (501-17 Roof Opening Panel, General Procedures).