• Navigator Manuals
  • Service
  • New
  • Top
  • Sitemap
Lincoln Navigator Manuals

Lincoln Navigator: Suspension System - General Information / Rear Toe Adjustment. General Procedures

Lincoln Navigator 2018-2026 Workshop Manual / Suspension / Suspension System - General Information / Rear Toe Adjustment. General Procedures

Special Tool(s) / General Equipment

Wheel Alignment System

Activation

NOTICE: Do not use any tools or equipment to move the wheel and tire assembly or suspension components while checking for relative movement. Suspension damage may occur. The use of tools or equipment will also create relative movement that may not exist when using hand force. Relative movement must be measured using hand force only.

NOTE: Make sure that the vehicle is standing on a level surface.

NOTE: Before carrying out a toe adjustment, check the tires for the correct pressure. Inspect the tires for incorrect wear or damage. Inspect the suspension for wear or damage.

  1. Using alignment equipment and the manufacturer's instructions, check the rear toe setting on both sides.
    Use the General Equipment: Wheel Alignment System
  1. NOTICE: The cam nut and cam bolt area must be free of foreign material to make sure of correct clamping.

    NOTE: Clean the general area of the joint to prevent foreign material from entering the joint. Clean the area using only mild liquids.

    On both sides.
    Loosen the toe link nut approximately one full turn.
  1. Jounce the vehicle to make sure that the suspension is in its normal, at-rest position.
  1. On both sides. Adjust the toe setting.
    Rotate the toe link bolt to achieve the specified toe setting.
  1. On both sides.
    Tighten the toe link nut.
    Torque: 203 lb.ft (275 Nm)
  1. Recheck the toe settings and adjust as necessary.

    Rear Camber Adjustment. General Procedures

    Special Tool(s) / General Equipment Wheel Alignment System Activation NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems...

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment Surface Gauge Check Ride Height Measurement — Front NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure...

    Other information:

    Lincoln Navigator 2018-2026 Workshop Manual: Factory Mode Deactivation. General Procedures


    Deactivation NOTE: During vehicle build, some modules, such as the IPC and BCM are set in factory mode. Factory mode reduces the drain on the battery during longer periods where the vehicle is not used. While in the factory mode, various systems may be altered or disabled and the IPC displays FACTORY MODE CONTACT DEALER in the message center...

    Lincoln Navigator 2018-2026 Workshop Manual: Knock Sensor (KS). Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the direct injection fuel rail LH and RH side. Refer to: Direct Injection Fuel Rail LH (303-04A Fuel Charging and Controls - 3.5L EcoBoost (272kW/370PS), Removal and Installation)...

    Categories

    • Manuals Home
    • 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
    • Liftgate Trim Panel. Removal and Installation
    • Telematics Control Unit (TCU) Module. Removal and Installation
    • Rear Bumper. Removal and Installation
    • Front Bumper Cover. Removal and Installation
    • Power Running Board (PRB). Diagnosis and Testing

    Axle Tube Bearing. Removal and Installation

    Special Tool(s) / General Equipment

    205-123 (T78P-1177-A)
    Installer, Axle Shaft Oil Seal 308-047 (T77F-1102-A)
    Remover, Bearing Cup Slide Hammer

    read more

    Copyright © 2026 www.linavigator4.com