Lincoln Navigator: Automatic Transmission - 10-Speed Automatic Transmission – 10R80 / Low One-Way Clutch Assembly. Diagnosis and Testing

Lincoln Navigator 2018-2026 Workshop Manual / Automatic Transmission / Automatic Transmission - 10-Speed Automatic Transmission – 10R80 / Low One-Way Clutch Assembly. Diagnosis and Testing

Low One Way Clutch

For low one way clutch operation,
REFER to: Low One-Way Clutch Assembly (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Description and Operation).

NOTICE: Do not clean with water or with water-based solvents. Damage to the component may occur.

Remove and inspect the low one way clutch for cracks and damaged splines. The splined section should lock in the direction of the number 1 arrow and rotate freely and smoothly when rotated in the direction of the number 2 arrow. Check for burned or excessively worn surfaces. If any damage is found or if the clutch does not rotate or lock, install a new low one-way clutch and front support and race assembly.

F Clutch. Diagnosis and Testing

Principles of Operation Symptom Chart F Clutch For F clutch operation, REFER to: F Clutch (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Description and Operation)...

Torque Converter Clutch (TCC). Diagnosis and Testing

Torque Converter Clutch (TCC) For torque converter operation, REFER to: Torque Converter (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Description and Operation)...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Transmission Strategy Download. General Procedures

Programming This procedure should be performed when a new transmission or main control valve body is installed in the vehicle. 13 - digit solenoid body strategy 12 - digit solenoid body identification If a new main control was installed, record the 13-digit solenoid body strategy from the replacement solenoid body tag provided with the main ..

Lincoln Navigator 2018-2026 Workshop Manual: Air Conditioning (A/C) Pressure Transducer. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect the electrical connector and remove the A/C pressure transducer. Torque: 71 lb.in (8 Nm) Installation To install, reverse the removal procedure. ..

Rear Drive Axle and Differential. Diagnosis and Testing

Symptom Chart(s)

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

Symptom Chart - Differential

Condition Actions Axle overheating GO to Pinpoint Test A Broken gear teeth on the ring gear or pinion GO to Pi