Lincoln Navigator: Exterior Lighting / Light Sensor. Removal and Installation
Special Tool(s) /
General Equipment
Removal
-
Using a non-marring tool release and position the light sensor.
Use the General Equipment: Interior Trim Remover
-
Disconnect the light sensor electrical connector and remove the light sensor.
Installation
-
To install, reverse the removal procedure.
Removal
Remove the rear spoiler.
Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Remove the bolts and the high mounted stop lamp assembly...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH (left-hand) headlamp assembly shown, RH (right-hand) headlamp assembly similar...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
BCM
B1175:01
Drivers Door Ajar Switch: General Electrical Failure
GO to Pinpoint Test A
BCM
B117..
Special Tool(s) /
General Equipment
6.5 mm Drill Bit
Spherical Cutter
Polydrive Bit Socket
Self-Piercing Rivet (SPR) Remover/Installer
Belt Sander
Blind Rivet Gun
Hot Air Gun
Air Body Saw
MIG/MAG Welding Equipment
Locking Pliers
Materials
Name
Specification
Metal Bonding AdhesiveTA-1, TA-1-B, 3M..