Lincoln Navigator: Body Closures / Liftgate Anti-Pinch Switch. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Disconnect the electrical connector.
-
Remove the retainers.
-
-
Remove the rubber grommet and route the electrical connector through the liftgate.
-
Remove the liftgate anti-pinch switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate window glass.
Refer to: Liftgate Window Glass (501-11 Glass, Frames and Mechanisms, Removal and Installation)...
Removal
NOTE:
Left hand (LH) side shown, right hand (RH) side similar.
Remove the liftgate.
Refer to: Liftgate (501-03 Body Closures, Removal and Installation)...
Other information:
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTICE:
The turbocharger compressor vanes can be damaged by even the
smallest particles. When removing any turbocharger or engine air intake
system component, ensure that no debris enters the system...
Removal
On the left side.
Remove the fender splash shield.
Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
Remove the RKE exterior sounder.
Disconnect the RKE exterior sounder electrical connector...