Lincoln Navigator: Handles, Locks, Latches and Entry Systems / Keyless Entry Keypad. Removal and Installation
Removal
NOTE:
The keyless entry keypad is serviced as an assembly with the front door upper moulding.
-
Remove the front door upper moulding.
Refer to: Front Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
-
Carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
NOTE:
LH side shown, RH side similar.
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Removal
NOTE:
Short wheelbase shown, long wheelbase similar.
Position the liftgate weatherstrip aside.
Release the clips and remove the liftgate scuff plate trim panel...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
ABS
B10DA:51
PATS Target Identifier: Not Programmed
GO to Pinpoint Test P
ABS
C0030:07
Left Fr..
Check
NOTE:
No factory-equipped vehicle should have more than a 25 mA
(0.025 amp) – 50 mA (0.050) draw depending on the vehicle's accessories.
Check for current drains on the battery in excess of 25 mA (0.025 amp) –
50 mA (0.050) with all the electrical accessories off and the vehicle
at rest for at least 75 minutes (depending on region). Current drains
can be tested with the fo..