• Navigator Manuals
  • Service
  • New
  • Top
  • Sitemap
Lincoln Navigator Manuals

Lincoln Navigator: Handles, Locks, Latches and Entry Systems / Interior Rear Door Handle. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Handles, Locks, Latches and Entry Systems / Interior Rear Door Handle. Removal and Installation

Removal

NOTE: LH side shown, RH side similar.

  1. Remove the rear door trim panel.
    Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
  1. Remove the bolts and the interior rear door handle bracket.
  1. Remove the bolts and the interior rear door handle.

Installation

  1. To install, reverse the removal procedure.

    Interior Front Door Handle. Removal and Installation

    Removal NOTE: LH side shown, RH side similar. Remove the front door trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

    Keyless Entry Keypad. Removal and Installation

    Removal NOTE: The keyless entry keypad is serviced as an assembly with the front door upper moulding. Remove the front door upper moulding...

    Other information:

    Lincoln Navigator 2018-2026 Workshop Manual: Leakage Inspection. Diagnosis and Testing


    Leak Check Test With the vehicle in NEUTRAL, position it on a hoist. REFER to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation). Inspect the gaskets and sealing areas for evidence of leakage...

    Lincoln Navigator 2018-2026 Workshop Manual: Passive Anti-Theft System (PATS) Center Antenna. Removal and Installation


    Special Tool(s) / General Equipment Interior Trim Remover Removal Release the clips and remove the floor console front trim panel. Use the General Equipment: Interior Trim Remover Remove the floor console finish panel bolts...

    Categories

    • Manuals Home
    • 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
    • Vehicle Dynamics Control Module (VDM). Removal and Installation
    • Telematics Control Unit (TCU) Module. Removal and Installation
    • Body and Paint
    • Rear Bumper. Removal and Installation
    • SYNC Module [APIM]. Removal and Installation

    Axle Tube Bearing. Removal and Installation

    Special Tool(s) / General Equipment

    205-123 (T78P-1177-A)
    Installer, Axle Shaft Oil Seal 308-047 (T77F-1102-A)
    Remover, Bearing Cup Slide Hammer

    read more

    Copyright © 2026 www.linavigator4.com