Lincoln Navigator: Handles, Locks, Latches and Entry Systems / Keyless Entry Rear Antenna. Removal and Installation
Removal
NOTE:
Short wheelbase shown, long wheelbase similar.
-
Position the liftgate weatherstrip aside.
-
Release the clips and remove the liftgate scuff plate trim panel.
-
Remove the load floor cover.
-
Position the load floor storage compartment cover up.
-
Remove the vehicle jack assembly.
-
Disconnect the keyless entry rear antenna electrical connector.
-
Remove the load floor storage compartment bolts.
-
Release the clips and remove the load floor storage compartment.
-
Remove the nuts and the keyless entry rear antenna.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
The keyless entry keypad is serviced as an assembly with the front door upper moulding.
Remove the front door upper moulding...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
System Diagram
E362131
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
1
SCCM
2
BCM
3
DDM
4
DSM
5
GWM
..
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully. Do not place any objects between the seat components
and the body of the vehicle, nor any objects within a joint internal to
the seat structure. Failure to follow step instructions may result in
incorrect operatio..
Keyless Entry Keypad. Removal and Installation
Liftgate Latch. Removal and Installation