Lincoln Navigator: Seatbelt Systems / Front Seatbelt Buckle. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: RH seat shown, LH seat similar.

1. Remove the front seat.
   Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
   

1. If equipped.
   Disconnect the front seatbelt buckle electrical connector.
   

1. 
   Remove the front seatbelt buckle.
   
   1. Detach the wiring harness retainer.
      
   2. Detach the wiring harness retainer.
      
   3. Disconnect the electrical connector.
      
   4. Remove the bolt.
      Torque: 30 lb.ft (40 Nm)

Installation

NOTE: During installation, make sure the seatbelt webbing is not twisted and the seatbelts and buckles are accessible to the occupants.

1. To install, reverse the removal procedure.
   

1. Check the seatbelt system for correct operation.
   Refer to: Seatbelt System Functional Tests (501-20A Seatbelt Systems, General Procedures).