Lincoln Navigator: Front Seats / Front Seat Track. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Front Seats / Front Seat Track. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the front seat backrest.
Refer to: Front Seat Backrest (501-10A Front Seats, Removal and Installation).

Remove the front seatbelt buckle.
Refer to: Front Seatbelt Buckle (501-20A Seatbelt Systems, Removal and Installation).

Remove the front seat cushion extension adjuster.
Refer to: Front Seat Cushion Extension Adjuster (501-10A Front Seats, Removal and Installation).

Remove the seat position sensor.
Refer to: Seat Position Sensor (501-20B Supplemental Restraint System, Removal and Installation).

Installation

All seats

NOTE: Transfer components to the new front seat track as necessary.
To install, reverse the removal procedure.

Seats with memory

NOTE: This step is only necessary when installing a new component.
Operate the seat in all directions through the full range of travel to set soft stops on all memory controlled functions and avoid a premature stopping point occurrence after the vehicle is returned to the customer.

Front Seat Power Lumbar Assembly - Vehicles With: Multi-Contour Seats. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Driver seat shown, passenger seat similar. NOTE: The front seat backrest driver seat SCMG (driver multi-contour seat module)/SCMH (passenger multi-contour seat module) is part of the front seat power lumbar assembly and is serviced as an assembly...

Front Seat Track Motor. Removal and Installation

Special Tool(s) / General Equipment Electric Drill Removal NOTE: Driver seat shown, passenger seat similar. NOTE: Positioning the seat fully upward provides access to service the seat track motor with the seat in the vehicle...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Joining Techniques. General Procedures

Special Tool(s) / General Equipment Spherical Cutter Plasma Cutter Air Body Saw 8 mm Drill Bit MIG/MAG Welding Equipment Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Repair NOTE: The following provide general joining options for sect..

Lincoln Navigator 2018-2026 Workshop Manual: Driver Door Module (DDM). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. This information must be downloaded into the new module after installation. Using a diagnostic scan tool, begin the PMI process for ..

Front Stabilizer Bar Link. Removal and Installation

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

NOTICE: Do not use power tools to remove or install the stabilizer bar