Lincoln Navigator: Front Seats / Front Seat Control Switch. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Front Seats / Front Seat Control Switch. Removal and Installation

Removal

NOTE: LH shown, RH similar.

Remove the front door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

Disconnect the front seat control switch and speaker electrical connectors.

Remove the bolts and the HVAC air duct.

Remove the front seat control switch and bezel.
1. Detach the speaker electrical connector.
1. Remove the screws.

Remove the screws and the front seat control switch.

Installation

To install, reverse the removal procedure.

Front Seat Bolster Paddle. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details...

Front Seat Cushion Adjuster - Vehicles With: Multi-Contour Seats. Removal and Installation

Removal NOTE: Driver seat shown, passenger seat similar. NOTE: The SCMG (driver multi-contour seat module)/SCMH (passenger multi-contour seat module) is part of the front seat cushion adjuster and is serviced as an assembly...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Impact of Insufficient Repair Quality. Description and Operation

Body repairs usually require a significant level of intervention in the existing body shell structure. The corrosion protection, seals and NVH components are destroyed and must be replaced. To prevent the vehicle quality from being compromised due to a poor quality repair, all repairs must be inspected during and after the accident repair...

Lincoln Navigator 2018-2026 Workshop Manual: Powertrain Control Module (PCM) Input and Output Controls. Diagnosis and Testing

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P0219:00 Engine Overspeed Condition: No Sub Type Information GO to Pinpoint Test Z PCM P0297..

Rear Camber Adjustment. General Procedures

Special Tool(s) / General Equipment

Wheel Alignment System

Activation

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Using alignment equipment and the manufacturer's instructions, measure the rear camber.
Use the General Equipment: Wheel Alignment System