Lincoln Navigator: Climate Control System - General Information / Evaporator Temperature Sensor. Removal and Installation
Removal
-
NOTE: The evaporator temperature sensor is available only as part of the evaporator assembly.
Remove the the evaporator.
Refer to: Evaporator (412-00 Climate Control System - General Information, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Evaporator. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...
Heater Core. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Brake Caliper. Removal and Installation
Removal NOTICE: Make sure that all openings are sealed. NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water. NOTE: Removal steps in this procedure may contain installation details...
Lincoln Navigator 2018-2026 Workshop Manual: Controller Area Network (CAN) Module Communications Network. Diagnosis and Testing
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action GWM U0001:09 High Speed CAN Communication Bus: Component Failures GO to Pinpoint Test AW GWM U02..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Windshield Washer Pump. Removal and Installation
- Body Control Module (BCM). Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
- Remote Function Actuator (RFA) Module. Removal and Installation
- Neutral Flat Tow Activation and Deactivation. General Procedures
Rear Camber Adjustment. General Procedures
Special Tool(s) / General Equipment
Wheel Alignment SystemActivation
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
Using alignment equipment and the manufacturer's instructions, measure the rear camber.Use the General Equipment: Wheel Alignment System
