Lincoln Navigator: Climate Control System - General Information / Heater Core. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
NOTE: If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle.
-
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation).
-
Remove the retainers and the heater core cover.
 |
-
Disconnect the clamps and remove the heater core inlet and outlet tubes.
 |
-
Remove the heater core.
 |
Installation
-
To install, reverse the removal procedure.
Evaporator Temperature Sensor. Removal and Installation
Removal
NOTE:
The evaporator temperature sensor is available only as part of the evaporator assembly.
Remove the the evaporator.
Refer to: Evaporator (412-00 Climate Control System - General Information, Removal and Installation)...
Heating, Ventilation and Air Conditioning (HVAC) Control Module. Removal and Installation
Removal
NOTE:
The HVAC module is available only as part of the FCIM .
Remove the FCIM .
Refer to: Front Controls Interface Module (FCIM) (415-00 Information
and Entertainment System - General Information - Vehicles With: SYNC 4,
Removal and Installation)...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Direct Current/Alternating Current (DC/AC) Inverter. Removal and Installation
Removal WARNING: Disconnect the 12 volt battery before servicing the direct current to alternating current (DC-AC) inverter or alternating current (AC) powerpoint to prevent the risk of high voltage shock. Failure to follow this instruction may result in serious personal injury...
Lincoln Navigator 2018-2026 Workshop Manual: Cylinder Head Temperature (CHT) Sensor. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the RH fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation). ...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- SYNC Module [APIM]. Removal and Installation
- Telematics Control Unit (TCU) Module. Removal and Installation
- Neutral Flat Tow Activation and Deactivation. General Procedures
- Remote Function Actuator (RFA) Module. Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
Rear Stabilizer Bar Link. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove and discard the 2 rear stabilizer bar link nuts and remove the rear stabilizer bar link.Torque: 46 lb.ft (63 Nm)
