Lincoln Navigator: Body Closures / Body Closures - Component Location. Description and Operation
| Item | Description |
|---|---|
| 1 | Liftgate anti-pinch switches |
| 2 | Power liftgate motors |
| 3 | RGTM |
| 4 | Hands-free liftgate actuation upper sensor (if equipped) |
| 5 | Hands-free liftgate actuation lower sensor (if equipped) |
| 6 | Hands-free liftgate actuation module (if equipped) |
| 7 | Power liftgate latch |
Body Closures - Overview. Description and Operation
Overview
The power liftgate feature allows power opening and closing of the liftgate using any of the following methods:
The front power liftgate switch (located on the instrument panel)...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Wheel Knuckle. Removal and Installation
Special Tool(s) / General Equipment 204-592/1Adapter for 204-592 Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense...
Lincoln Navigator 2018-2026 Workshop Manual: Front Drive Axle and Differential. Description and Operation
The front drive axle consists of: A cast-aluminum center section, a removable cast-aluminum axle housing tube and a differential housing cover. Both the axle housing tube and the differential housing cover use silicone sealant as a gasket...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Front Bumper Cover. Removal and Installation
- Power Running Board (PRB). Diagnosis and Testing
- Identification Codes. Description and Operation
- Telematics Control Unit (TCU) Module. Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
Front Stabilizer Bar Link. Removal and Installation
Removal
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTICE: Do not use power tools to remove or install the stabilizer bar
