Lincoln Navigator: Passive Anti-Theft System (PATS) - Vehicles With: Phone as a Key / Bluetooth Rear Exterior Antenna. Removal and Installation
Special Tool(s) /
General Equipment
Removal
-
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
-
Remove the bluetooth rear exterior antenna.
-
Disconnect the bluetooth rear exterior antenna electrical connector.
-
Release the bluetooth rear exterior antenna clip.
Use the General Equipment: Interior Trim Remover
Installation
-
To install, reverse the removal procedure.
-
Using the diagnostic scan tool, carry out the remote function actuator (RFA) module self test.
Removal
NOTE:
RH (right hand) shown, LH (left hand) similar.
Remove the front door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left hand) shown, RH (right hand) similar.
Remove the loadspace trim panel...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to upload the
module configuration information to the scan tool prior to removing the
module. This information must be downloaded into the new module after
installation...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the EVAP canister.
Refer to: Evaporative Emission Canister (303-13 Evaporative Emissions - 3.5L EcoBoost (272kW/370PS), Removal and Installation)...